12.5 mm / 0.49 in Off-White Plastic Cap 54 System Production Snap Buttons 100 Sets ERC00125PLKBeyaz

This 12.5 mm / 0.49 in off-white plastic cap snap gives workshops a consistent fastening format for prototypes, sample garments, capsule collections and repeat light-apparel styles. The coloured cap provides the visible finish, while the three stainless silver lower parts complete the 54 System S-spring mechanism.

Designed for sampling and controlled repeat work

The 100-set format is useful when a workshop needs enough components for actual garment testing without moving directly into a large-volume order. It supports colour trials, construction approval, repair work and small production runs using the same snap structure.

Off-white has a softer appearance than optic white, but it should not be listed as ecru. Designers working with strict colour standards should approve the snap beside the final fabric under the intended lighting conditions.

Plastic cap does not mean fully plastic

Only the visible top cap is plastic. The socket, stud and post are metal components. This distinction affects product selection, die choice and finished appearance. Use the plastic snap fasteners category to compare plastic-cap products with fully plastic alternatives.

Pack structure

Each complete snap has four components: one cap, one socket, one stud and one post. A 100-set pack therefore contains 400 individual components. Keep the components organised by system and finish during sampling so incompatible lower parts are not introduced into production.

Setting requirements

Use the matching 12.5 mm / 0.49 in plastic cap 54 System snap setting die. Confirm the cap shape, die thread and machine connection before installation. The snap pack does not include a die, press or punching equipment.

Apply controlled pressure and inspect the first samples before repeating the setting process. Excessive pressure or an unsuitable cap cavity may mark or deform the plastic surface, while insufficient pressure may leave the components poorly seated.

Workshop applications

• Babywear and children’s apparel sampling
• Bodysuits, rompers and shirts
• Sleepwear and lightweight uniforms
• Boutique and capsule collection production
• Alterations and replacement work
• Colour and construction approval samples

Pre-production approval checklist

• Verify the 12.5 mm / 0.49 in measurement and 54 System format.
• Confirm that the cap colour matches the approved fabric.
• Check die and machine-thread compatibility.
• Test the actual fabric construction and number of layers.
• Evaluate opening force, cap alignment and reverse-side appearance.
• Complete relevant wash and wear testing before volume production.

Ordering caution: A generic 12.5 mm die is not automatically compatible. The setting tool must match the snap system, plastic cap profile, lower component structure and machine connection.

Frequently Asked Questions

Is this pack suitable for prototype garments?

Yes. The 100-set quantity is suitable for sampling, prototype work, alterations and small production runs.

How many individual components are supplied?

The pack contains 100 four-part snap sets, providing 400 individual components in total.

Can I mix these parts with another 54 System snap?

Mixing is not recommended without a compatibility check. Cap and lower-part profiles may vary even when products use the same general system name.

What installation equipment is required?

A matching 12.5 mm / 0.49 in plastic-cap 54 System setting die and compatible press or setting machine are required.

Is the off-white cap suitable for optic-white fabric?

It can create a visible tonal difference. Compare the actual cap with the fabric before production if a precise colour match is required.

What should be checked after the first installation?

Check cap alignment, surface marks, component seating, closure feel, holding performance and the condition of both sides of the material.